FORNEY EASY WELD 20 P PLASMA CUTTER QUICK START GUIDE

Get started with the Forney Easy Weld 20 P Plasma Cutter! This is a breakdown of the Quick Start Guide that is included with your new machine.

1. Read User Manual

2. Connect to input air (Output air pressure is pre-set at the factory)

a. 60-100 PSI

b. ≥ 1.5 CFM

c. Clean air

d. No oil

e. No moisture

3. Connect to Input Power

a.Generator OK with continuous output ≥ 4,000 W

b.Extension cord: #12 AWG or larger; 25’ (8m) or shorter

4. Drag tip on work piece

Travel Speed

Cutting capability

Replace worn consumables

Replacement electrodes and cutting tips available in a 4-pack (2 ea.) ITEM# 85392

4 Comments

Richard E Hawkins on September 6, 2021 at 11:09 am

My P20 will not cut even with new electrode and cup . Power is on and 100 psi air pressure and good ground

Rachel Bigum on September 7, 2021 at 9:22 am

Hi Richard! Sorry to hear you’re having issues with your Forney Easy Weld 20 P. Our Expert-Techs should be able to help you out! Give them a call at 1-800-521-6038 ext. 2. Thanks for reaching out!
Reply

Judy C Wills on March 27, 2021 at 12:01 pm

do you make a guide for this machine

4 Comments