Select Page

Get started with the Forney Easy Weld 20 P Plasma Cutter! This is a breakdown of the Quick Start Guide that is included with your new machine.

Forney Easy Weld 20 P Plasma Cutter Machine


1. Read User Manual Icon Read User Manual

2. Connect to input air (Output air pressure is pre-set at the factory)

a. 60-100 PSI

b. ≥ 1.5 CFM

c. Clean air

d. No oil

e. No moisture

Air fitting connector

3. Connect to Input Power Input Power Symbol

a.Generator OK with continuous output ≥ 4,000 W

b.Extension cord: #12 AWG or larger; 25’ (8m) or shorter

120VAC, 20A outlet, 30A breaker recommended

4. Drag tip on work piece

Correct- Wrong Example
Correct Consumable Assemply Diagram

Operating Tips

Travel Speed

Correct- Wrong Examples, Too fast. Watch spark trail angle.

Cutting capability

  • Will cut clean up to 1/4” (6.4 mm)
Quarter inch cut

Replace worn consumables

  • Replacement electrodes and cutting tips available in a 4-pack (2 ea.) ITEM# 85392
New consumables- Worn consumables

Troubleshooting Guide

Solid yellow; Duty cycle exceeded; Allow machine to cool. See manual
Flashing green; Low input power; Verify power source is 120 VAC +/- 10%
Flashing red; Consumables not in place properly; Check consumable assembly. Tighten cup. See manual.
Flashing yellow; Low input air pressure; Ensure air input meets pressure and flow requirements.
Forney Easy Weld 20 P Button