Get started with the Forney Easy Weld 20 P Plasma Cutter! This is a breakdown of the Quick Start Guide that is included with your new machine.
FIRST STEPS
1. 
2. Connect to input air (Output air pressure is pre-set at the factory)
a. 60-100 PSI
b. ≥ 1.5 CFM
c. Clean air
d. No oil
e. No moisture
3. Connect to Input Power 
a.Generator OK with continuous output ≥ 4,000 W
b.Extension cord: #12 AWG or larger; 25’ (8m) or shorter
4. Drag tip on work piece
Operating Tips
Travel Speed
Cutting capability
- Will cut clean up to 1/4” (6.4 mm)
Replace worn consumables
- Replacement electrodes and cutting tips available in a 4-pack (2 ea.) ITEM# 85392
Troubleshooting Guide
