Get started with the Forney 700 P Plasma Cutter! This is a breakdown of the Quick Start Guide that is included with your new machine.
FIRST STEPS
1. 
2. Use dedicated electrical circuit and quality compressor with moisture and dirt filter. (Compressor performance can directly affect plasma cutting performance).
a. Optimal Pressure = 65 PSI
b. Optimal Flow = 3.5 cu ft/min
3. Use a piece of scrap sheet metal and perform a test cut.
4. Make sure your tip stays in contact with the work piece.
5. Replace electrode or tip when damaged or if they show excessive wear.
Cutting Tips
Contact cutting
- Drag torch while holding at a 15-30° angle.
Cutting Capability
- Stay within cutting limits of the machine.
Cutting Guide
- Use a metal straight edge to control cuts.
Remove Moisture
- Built in moisture trap extends tip life, and needs to be drained periodically.
Warning: To prevent fire and serious injury: Keep torch and wire clear of grounded objects while welder is plugged in. Be sure to follow safe welding procedures and wear proper PPE (clothes, welding helmet, safety glasses, welding gloves, boots, etc.)
